What the Medley Ring Sling gives you for a newborn carry
The Medley Ring Sling is a buckle-free carrier: you adjust it by sliding the fabric through the rings, with no snaps or buckles to fuss with. That simple mechanism is what makes a secure newborn fit possible, but it also means the fit depends on how carefully you thread and tighten the fabric.
The carrier is rated for babies from 7 to 35 lbs in front and hip carries. For a newborn, that means the lower end of the range is your reference point, and the front carry is the position the record supports. The fabric is 55% hemp and 45% organic cotton, with no synthetic fibers, and it softens with every wash. Hemp and cotton have little give, so the sling holds its shape once tightened rather than stretching out as you move.
Medley Ring Sling details that affect a newborn fit
- Medley Ring Sling: Carries babies from 7 to 35 lbs in front and hip carry positions. The 7 lb lower limit is your starting checkpoint: confirm your baby meets it before your first wear, and use front carry for a newborn.

Medley Ring Sling - Medley Ring Sling: Adjusts by sliding the fabric through the rings, with no buckles or snaps. Threading and ring tension are the whole fit system, so the steps below focus on getting the fabric through the rings cleanly and tightening in small increments.
- Medley Ring Sling: Made from 55% hemp and 45% organic cotton, with no synthetic fibers, and softens with every wash. A low-stretch fabric holds a tightened seat better than a stretchy one, but a brand-new sling may feel firmer until it has been washed.
- Medley Ring Sling: Comes in Short (74"), Mid (84"), and Long (94") lengths, with Black or Bronze rings depending on the variant. Length changes how much fabric you have to thread and tighten, so pick your size before you start practicing the fit.
How to thread the Medley Ring Sling
Threading is the foundation of a secure ring sling setup. Do this before you put your baby in, with the sling off your body or loosely over one shoulder so you can see the rings clearly.
- Find the rings and the tail: Lay the sling out so the two rings sit together at one end and the long tail of fabric is free. The rings are anodized aluminum: smooth, strong, and made to last.
- Gather the fabric along the width: Take the edge of the fabric nearest the rings and bunch it along its width, keeping the fabric flat rather than twisted. A twisted thread is the most common reason a sling feels uneven later.
- Pass the gathered fabric through both rings: Push the bunched fabric through both rings from the back toward you, then fold it over the front ring and pull it through the space between the two rings. This is the same path the fabric will follow every time you wear it.
- Spread the fabric over the rings: Fan the fabric so it covers the rings evenly, edge to edge. Even coverage spreads the load and keeps the rings from digging in.
- Check the thread before loading: Hold the sling up and look for twists or a bunched section near the rings. Fix them now; it is much harder to correct once your baby is in.
Putting your newborn into the ring sling position
With the sling threaded and over one shoulder, the rings should sit high on your chest, roughly where a brooch would, so the fabric has room to form a seat. Hold your baby against your chest and bring the fabric up over their back and bottom, keeping the lower edge tucked under their legs rather than across their tummy.
The supplied record describes the Medley as ideal for quick ups and downs, newborn snuggling, and hands-free errands. Those uses all depend on a seat that stays put, so take the time to settle your baby into the fabric before you tighten.
Ring sling tightening tips for a snug newborn seat
Tightening is where a ring sling either feels secure or feels like it is slipping. Work in small sections rather than pulling one long tail.
- Tighten the top rail first: Pull the upper edge of the fabric through the rings until it supports your baby's back and shoulders. This rail controls how close your baby sits to your chest.
- Then tighten the bottom rail: Pull the lower edge until the fabric cups under your baby's bottom. A firm bottom rail is what keeps the seat from sagging.
- Work section by section: Pull small sections of fabric through the rings in sequence from top to bottom, rather than grabbing the whole tail at once. This keeps the fabric even across your back and shoulder.
- Re-check the rings: After tightening, the fabric should still cover the rings evenly. If it has bunched to one side, loosen slightly and redistribute before continuing.
- Do a final reach test: Raise and lower your arms and bend forward gently. The sling should stay in place without the fabric sliding through the rings.
Newborn ring sling safety checkpoints
The Medley Ring Sling meets ASTM F2907 safety standards for sling carriers. The standard covers the carrier; the fit is still yours to check each time you wear it.
- Confirm the weight range: The record lists 7 to 35 lbs. If your newborn is below 7 lbs, the supplied information does not confirm suitability, so check with your baby's healthcare provider before wearing.
- Keep the face clear: Your baby's face should stay visible and away from your body and the fabric. Tighten the top rail enough to support the back, but not so high that it covers the face.
- Check the seat after every adjustment: The bottom rail should stay under your baby's legs, not across the tummy. Re-check it each time you loosen or tighten the sling.
- Use the carries the record supports: The Medley is listed for front and hip carry. The supplied information does not describe a back carry for this carrier, so keep a newborn in front carry.
- Inspect the rings and seams before each use: Look for fabric wear near the rings and check that the thread path is even. If anything looks damaged, stop using the sling.
Choosing your length and ring color before you practice
The Medley comes in Short (74"), Mid (84"), and Long (94") lengths, with Black or Bronze rings depending on the variant. Length affects how much tail you have to pull through the rings: a shorter sling leaves less fabric to work with, while a longer one gives you more to tighten in sections. If you are between sizes or unsure, the supplied information does not include a sizing chart, so it is worth trying the length you expect to use most before committing.
The sling is sewn by fairly paid sewing teams in Minnesota, and the hemp-cotton fabric softens with every wash. That means a new sling may feel a little stiff at the rings for the first few wears; the threading and tightening steps above are the same, but expect to pull a bit more firmly until the fabric breaks in.

